OBSERVABILITY Signal 418
3D-printable 'Flock Sock' design shared for covering Flock cameras via broom handle
↗
A 3D printing enthusiast named SquidInk publicly shared a 3D-printable slip-on cover called the 'Flock Sock' that fits over Flock surveillance cameras using a broom handle, though deploying it likely constitutes a crime.
This moves camera obstruction from ad-hoc methods like trash bags and spray paint to a reproducible, non-destructive design anyone can print and install in seconds. The creator emphasizes non-permanence, no glue, no screws, zero structural changes, as a potential legal distinction, but the article warns this likely still qualifies as tampering with public infrastructure. The tool's existence reflects escalating public opposition to Flock cameras following documented police misuse and wrongful apprehensions.
Written by elseif from the cluster below · every claim links back to a sourceThe three things worth knowing
The 'Flock Sock' slides onto Flock cameras in seconds using a 1-inch broom handle adapter and currently fits one of three Flock camera models, with profiles for the other two in development.
The design is non-permanent with no glue, screws, or structural changes, and the creator recommends ABS/ASA filament for heat and UV resistance over PLA.
Tampering with Flock cameras likely constitutes a crime or misdemeanor, with possible charges including vandalism, criminal mischief, property damage, tampering with public infrastructure, and obstruction.
THE CLUSTER